Euro Pro Serger Instructions

Euro Pro Serger Instructions

Sergers made through Euro seasoned are robust sewing machines that produce even stitches. The fundamental operation of the device starts offevolved with needle placement, putting in place the threads and chaining off. The Euro pro serger version 101-548 is a 2-three-4 thread machine and can function with two threads, three threads or 4 threads. here is how to set up and perform the serger.

The needle is the first element to test and set up while working this serger. The serger makes use of standard stitching gadget needles with the flat heads. This way, the needles can simplest be inserted one way, stopping errors and jamming with the rounded component facing front and the flat component going through rear. There are holes for the needles. The right slot is for the right overedge needle, and the left slot is for the left overedge needle. as soon as they are inserted, the proper overedge needle will be slightly lower than the left one whilst dealing with the gadget.

The serger has a four-thread guide keep for the serger cone thread spools. Pull up the thread manual to extend it all the way until it clicks into place. If using regular stitching system thread rather than serger cone thread use the spool cap to hold it into location while serging.

This serger may be very clean to string. by using searching at the colours at the gadget and the inner front cowl, following the order is straightforward. The higher looper is orange, the lower looper is yellow, the right needle is inexperienced and the left needle is blue. Use tweezers and use the serger's manual if needed, and follow the shade coded direction to pull all the threads so one can be used thru the machine. Thread the serger on this order: loopers then thread. The top looper is going first observed by the lower looper. If the usage of both needles, thread the right needle first and the left needle ultimate.

The stitch dial for the period is located all of the way on the right side of the machine and is manufacturing facility set at the setting "3," which is a 3mm or 1/eight inch period. flip the dial up or down to adjust the length. as an example, the putting "4" is 4mm (five/32 inch) and "2" is 2mm (five/sixty four inch). The width of the serged seam is depending on the needle or by way of adjusting the knob for the width. With the left needle simplest sewing, the width is ready to 7/32 inch, and with the right needle handiest stitching, it's far set to nine/sixty four inches. additionally, by using pushing inside the width adjustment knob at the back of the front cover, the sewing may be adjusted manually from 1/8 inch to 17/sixty four inch wide.

once the thread has been guided through the gadget and thru the needles, pull all of them collectively over the needle plate and out underneath the presser foot to the left. begin to manually turn the hand wheel in the direction of you flippantly and the chain will start to broaden. region a chunk of scrap cloth under the presser foot and push the foot pedal to begin to slowly chain stitch the pattern. If there are any changes that need to be made, make them now before serging the garment.

Source: here

Leave a comment